Follow us on the Gram! dirtyoptics My new years resolution was to make a start learni Since zero progress has been made on the EV (some Do u know what your looking at?? Me neither! Haha Motor mount template done! Picked up a couple mino It worked! I was pretty skeptical. 1 x adapter tem I’m not the greatest in the CAD software but whe Framing the @onefinitycnc Yet to cut the adapter p It’s sink or swim tomorrow. Got some templates ( And some people tell me that 3D printing is not us Unfinished mess! Nothing some sanding and stain wo Its that time of year again! Epoxy filled 2.5D Aus Had a few msgs about the batteries. I’ll do a co Any guesses what these are?? . . . #ev #diyev #gem Ok, This is the last of the CAD porn! (No promise! Its coming together! If your not sure what your lo Sneaky little peak! . . . #diyev #ev #dirtyoptics Make note to self….do not drop the expensive ele Won’t lose this bad boy in a hurry! . . . #allen Tried my luck engraving Rocker cover switches. Mix Few new pieces of the puzzle! So close to a bench 9kgs Vs 6kgs Flywheel. Not sure if this will trans Well I did what I could without ripping all the wi My happy place…🤓 8 LED bars from Kings for the win! Saved myself so Spoilboard down! Now to tidy up some wiring, clad Ran the control cable for the spindle and started Decided to mount on some extruded ally for the add One more piece of the puzzle solved! Thanks to @li A bit of cleaning up and some small additions at t When you think its square and level…it never rea Look what rocked up! Going to be a busy weekend co A productive Saturday morning down at the workshop Check out some of the legendary work of @robshamma The great ‘Plywall’ of Bibra Lake is coming al The Ch..Ch..Chiron by Anycubic is HUGE! Lets see i Finally some EV parts. I know its a bit boring but To be glued and painted. But not bad for first pri A blank canvas! Can you spot the new eyes in the s Small wins this week! Since moving the workshop no Load More Follow on Instagram
